These error codes indicate an internal error in the charger. Charging is not possible while the error is active. In OCPP this is reported as InternalError. The same applies to error codes 1050 to 1056, 1060, 1062 to 1064 and 1100.
What to do
Reboot the charger from the web interface or Connect Hub, or ask your charge point operator to reset it from the back office. If the web interface is not reachable, perform a power cycle: switch off the power to the charger at the fuse box, wait a moment and switch it back on. Then start a new charging session.
If the error persists, download the diagnostics of the charger and contact Peblar support or your installer.